Removing A Pci Expansion Card - Gateway 9515 User Manual

9
While holding the blue lever in, line up the holes in the replacement PCI riser
connector with the riser retention pins, then place the connector on the retention
pins.
10
Slide the PCI riser connector toward the front of the PCI riser assembly, then release
the blue lever, locking the connector into place.
11
Follow the instructions in
12
Replace the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
13
Follow the instructions in
14
Follow the instructions in
15
See the card's documentation for software installation instructions.

Removing a PCI expansion card

To remove a PCI expansion card:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in
3
Follow the instructions in
82
"Installing a PCI expansion card" on page
79.
"Installing the processor air duct" on page
"Closing the server case" on page
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the processor air duct" on page
www.gateway.com
83.
"Removing and
50.
46.
43. Make
44.
47.