Rotating And Installing The Front Cover Drive Faceplate; Installing The Rackmount Handles - Gateway 960 Installation Manual

Installing Your Gateway Server into a Rackmount Cabinet
Rotating and installing the front cover drive
faceplate
To rotate and install the front cover drive faceplate:
1
Press the faceplate release tabs inward to remove the drive bay faceplates
from the front cover, then pull the faceplates away from the front cover.
2
Rotate the faceplates 90 degrees, then snap them into the front cover slots
that correspond to the drive bays you will not use.

Installing the rackmount handles

Tools you need to complete this task:
Rackmount kit parts you need to complete this task:
12
2 rackmount
handles
www.gateway.com
Phillips screwdriver
8 hex screws
#6-32 × 0.25
"