Gateway 9515 User Manual page 111

4
Press the blue latch at the back of the control panel module, then slide the module
out of the chassis enough to reach the USB and front panel cables.
Important
Front panel
5
Disconnect the USB and front panel connectors from the control panel module, then
remove the control panel from the chassis.
Caution
Important
6
Slide the new control panel module into the chassis far enough to let you connect
the USB and front panel cables.
7
Connect the USB and front panel cables to the control panel module, then slide the
module into the chassis until it clicks into place.
8
If you disconnected the USB and front panel cables from the system board or
backplane when you removed the control panel module, reconnect the cables.
106
You may need to disconnect the USB and front panel cables from
the system board or backplane to provide sufficient slack in the cables
to gain access to the control panel cable connectors.
cable
The USB header has a latch to hold the connector on. Be careful to
unlatch the USB connector when removing it from the control panel
or you could damage the connector or the header.
The position of the USB connector is different in the standard control
panel than in the optional local control panel. Note the positions of
the cable connectors as you remove them from the module.
www.gateway.com
USB cable
Latch