Installing The Scsi Sixth Drive Option - Gateway 9515 User Manual

9
Route the SCSI cable along the front of the fan module, then through the openings
in the underside of the large air baffle. Follow the instructions in
baffles" on page 50
10
Attach the end of the SCSI cable labeled "Server Board" to the SCSI connector on your
add-in SCSI card.
11
Connect the 7-pin tape drive power cable to the "OPT CONN" connector on the
hot-swap drive backplane, the connect the 4-pin tape power cable from the backplane
to the tape drive.
12
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
13
Follow the instructions in

Installing the SCSI sixth drive option

A sixth SCSI drive may be added to your server by using the SCSI backplane accessory kit.
Once the kit is installed, an additional hot-swap hard drive may be installed in the server
(see "Installing a hard drive" on page
Important
To install the sixth drive option:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
Caution
2
Follow the instructions in
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Remove the filler panel from the sixth drive bay by using a long bladed screwdriver
to push it out the front of the chassis.
5
Remove the fan module by following the instructions in
on page 85.
and "Installing the air baffles" on page
"Closing the server case" on page
64).
You cannot install both the sixth drive option and a tape drive. Due
to size limitations, the tape drive occupies the sixth drive bay and the
space above it.
"Preventing static electricity discharge" on page
The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off.
"Opening the server case" on page
www.gateway.com
"Removing the air
53.
46.
43. Make
44.
"Replacing the fan module"
69