Replacing The Hot-Swap Backplane - Gateway 9515 User Manual

Replacing the hot-swap backplane

To replace the hot-swap backplane:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in
3
Remove the bezel by pulling it straight off the front of the server.
4
Remove each of the drives from the server, including any drive in the Slim-Line drive
bay, and make note of which bay you remove each drive from. For instructions, see
"Removing a CD or DVD drive" on page
5
Remove the fan module by following the instructions in
on page 85.
6
Remove the large hot-swap air baffle by following the instructions in
air baffles" on page
7
Disconnect all cables from the backplane.
8
Holding the backplane by the edges only, lift it from the chassis.
Caution
100
"Preventing static electricity discharge" on page
"Opening the server case" on page
50.
Pressing or pulling on any components on the backplane could result
in damage to the backplane.
www.gateway.com
63, and "Installing a hard drive" on page
"Replacing the fan module"
43. Make
44.
"Removing the
64.