Installing The System Drawer; Installing The Mounting Rails - Gateway ALR 7200R User Manual

Note:
Drawer heights are
measured in U's. Each U is
equivalent to 1.75 inches.
The ALR 7200R is 6U's
(10.5 inches) high.
8 Gateway ALR 7200R User's Guide Supplement

Installing the System Drawer

Installing the Mounting Rails

1. Remove the side rails from the mounting rails, by depressing the
retention clips and sliding them off.
2. Mount the side rails on the system chassis with the 8 screws (4 to each
side) provided. The retention clips should go toward the rear of the
cabinet.
If the mounting rails have not previously been installed, position the
3.
drawer template (P/N 65770050-00) in the cabinet so that the side
matches the corresponding side you wish to install.