Replacing The Bezel - Gateway 8400 System Manual

Replacing the bezel

To remove the bezel:
1
With the tower in the upright position, open the system door and lift
the door so that the hinge pins (2) come out of the hinge-pin sockets.
2
Pull the door away from the bezel and set it aside.
3
Beginning at the top left inside edge of the bezel, depress the plastic
retention tabs toward the outside edge of the bezel, and pull the bezel
out from the chassis slightly, enough to keep the tabs from snapping back
into place.
4
Work your way around the bezel until all eight tabs (three left, one
bottom, two right, and two top) have been released, then pull the bezel
off the chassis.
Retention tabs
Note: Other
retention tabs
not visible
Replacing the bezel
69