Gateway 9515 User Manual page 67

6
Align the connector on the interposer board with the connector on the back of the
CD or DVD drive, then attach the board to the drive with two screws (included with
your server).
7
Attach the 44-pin CD drive cable to the back of the interposer board.
8
Slide the CD or DVD drive assembly into the slim-line bay until it clicks into place.
9
Connect the other end of the 44-pin cable into the connector on the backplane. See
"Hot-swap backplane" on page 8
10
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
11
Follow the instructions in
12
Reconnect all power cords and peripheral device cables, then turn on the server.
62
for the location of the connector.
"Closing the server case" on page
www.gateway.com
46.