Gateway 9515 User Manual page 86

To remove and install a PCI riser connector:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in
3
Follow the instructions in
4
Remove the PCI riser assembly from the server by following the instructions in
"Removing and installing the PCI riser assembly" on page
5
Remove any installed PCI expansion cards by following the instructions in
a PCI expansion card" on page
6
Push in on the blue release lever at the end of the PCI riser connector.
7
While holding the lever in, push firmly on the front edge of the PCI riser connector,
then slide it to the back to disengage the connector from the riser retention pins.
8
Place the PCI riser connector in a static-free bag to store it for future use.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the processor air duct" on page
82.
www.gateway.com
43. Make
44.
47.
79.
"Removing
81