Table of Contents
Advertisement
Installing the processor air duct
To install the processor air duct:
1
Place the processor air duct over the processor sockets. The front edge of the air duct
should contact the fan module, and the top of the installed air duct should be flush
with the top of the power supply.
2
Follow the instructions in
Removing the air baffles
Your server is equipped with a hot-swap backplane, supporting hot-swap SATA or SCSI hard
drives, so your server has two air baffles.
■
A small air baffle attached to the drive cage area, in front of the hard drive backplane.
■
A large air baffle installed between the power supply and the back of the backplane.
Caution
50
"Closing the server case" on page
To ensure continued, reliable operation, always operate your server
with the appropriate air ducts, air dams, and baffles in place. Failure
to do this could result in equipment damage.
www.gateway.com
46.
Advertisement
Table of Contents
Troubleshooting
