Table of Contents
Advertisement
Messages regarding paper
Leading edge detection error.
A roll has been loaded when sheets are selected as
the paper source on the Control Panel.
The sheet is loaded askew.
Cannot feed paper.
Paper came out of the feed path during feeding.
Cannot cut this paper.
There are sheets left on the Ejection Guide.
There is a foreign object by the Output Tray,
obstructing the Cutter Unit.
You are not using the printer under the recommended
environmental conditions for the paper.
You are using paper that is not compatible with
automatic cutting.
The Cutter Unit stops in the middle of cutting.
The Cutter Unit is not installed.
In other cases, the Cutter Unit may be damaged.
End of paper feed.
You are pressing the ▲ button on the Control Panel
and trying to rewind the roll to the edge.
Rel lever is in wrong position.
The Release Lever is pushed back.
636 Error Message
Cause
Cause
Cause
Cause
Cause
Corrective Action
Either remove the roll and load a sheet or select the
roll as the media source on the Control Panel.
Reload the sheet straight, in the correct position.
(→P.135)
Corrective Action
Reload the paper correctly and advance it again.
(→P.110)
If the message is displayed when paper is not being
advanced, contact your Canon dealer for assistance.
Corrective Action
Remove the paper.
Remove the foreign object.
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see "Types of Paper". (→P.95)
Cut the roll manually.
(→P.124)
Move the Carriage to the left, remove the paper, and
return the Carriage to the right. If the roll cannot be
cut using the Cutter Unit, cut the roll manually.
(→P.116)
(→P.124)
Install the Cutter Unit.
(→P.577)
Contact your Canon dealer for assistance.
Corrective Action
Release the ▲ button.
Corrective Action
Pull the Release Lever forward.
Advertisement
Chapters
Table of Contents
