Starting With Intermec Shell - Intermec EasyCoder 501 XP User Manual

Chapter 8 Intermec Shell Startup Program

Starting with Intermec Shell

68
A few seconds after you have switched on the power to the printer and
the initialization is completed, the countdown menu of the Intermec
Shell program will be displayed:
ENTER=SHELL
5 sec. v.4.8
Now you have 5 seconds to enter Intermec Shell by pressing <Enter>.
The lower line tells you how much time you have left. Should the
time run out before you have taken any action to enter Intermec
Shell, the last selected application in Intermec Shell will be opened. If
you use the same application all the time, you will only need to switch
on the power, once the application has been selected.
If no other application has yet been selected, the current version
of Intermec Fingerprint will be opened with the standard RS-232
port "uart1:" selected as std I/O channel (see Intermec Fingerprint
manuals). When the countdown is completed, you will see these lines
in the display:
FINGERPRINT
7.61
If you want to select another application, just cycle the power and
enter Intermec Shell before the countdown is completed.
When you enter the Intermec Shell from the countdown menus, the
Select Application menu will be displayed:
SHELL
SEL. APPLICATION
In this menu, you can choose between two options:
• Press <Enter> to go to menus where you can select an application
program.
• Press <F5> to go to the Facilities part of Intermec Shell.
Intermec EasyCoder 501 XP – User's Guide