Intermec EasyCoder 501 XP User Manual page 101

Media, cont.
Tickets with Black Mark
a
e
f
g
c d
TICKETS
FEED
DIRECTION
Intermec EasyCoder 501 XP – User's Guide
a
Maximum:
Minimum:
b
Minimum:
Maximum:
c
The distance between the inner edge of the media and the inner
edge of the black mark must be:
Maximum:
b
Minimum:
d
The detectable width of the black mark must be:
Minimum:
e
No restriction, but the LSS cannot detect the mark more than 50
mm (1.97 inches) from the inner edge of the media.
f
Maximum:
Common:
Minimum:
g
It is recommended to place the black mark as close to the front
edge of the ticket as possible and use a negative Stop Adjust
value to control the media feed, so the tickets can be properly
torn or cut off.
Media Type Setup:
• Ticket (w mark)
Important! Preprint that may interfere with the detection of the black
mark should be avoided on the back of the media. However, the
LBLCOND statement allows the sensor to be temporarily disabled
during a specifi ed amount of media feed in order to avoid uninten-
tional detection, see Intermec Fingerprint manuals.
The black mark should be non-refl ective carbon black on a whitish
background.
Do not allow any perforations to break the edge of the media, as this
may cause the media to split and jam the printer.
Appendix 2 Media Specifi cations
Media Width:
Copy Length:
Black Mark Offset:
Black Mark Width:
Black Mark End:
Black Mark Height:
Black Mark Y-Position:
120.0 mm (4.72 inches)
25.4 mm (1.00 inches)
20.0 mm (0.8 inches)
depends on DRAM memory size
40.0 mm (1.57 inches)
0.0 mm (0.0 inches)
10.0 mm (0.4 inches)
21.3 mm (0.83 inches)
12.5 mm (0.5 inches)
5.0 mm (0.2 inches)
99