Intermec EasyCoder 501 XP User Manual page 100

Appendix 2 Media Specifi cations
Media, cont.
Tickets with Gap
a
b
c
f
d
e
TICKETS & TAGS
FEED
DIRECTION
98
a Media Width:
Maximum:
Minimum:
b Copy Length:
Min. length between slots:
Max. length between slots:
Under ideal circumstances, a minimum label length of 4 mm (0.16
inches) could be used. It requires the sum of the label length (d) and
the label gap (e) to be larger than 7 mm (0.28 inches), that batch
printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short labels will work, but it is
up to the user to test this in his unique application.
c Detection Slit Start:
The restriction of the minimum detection slit length (d) must
be observed and the slit must not break the inner edge of the
media.
d Detection Slit Length:
The length of the detection slit (excluding corner radii) must be:
Minimum:
inches)
e Detection Slit End:
Provided the restrictions of the minimum slit length (d) and
slit start (c) are observed, the distance from the inner edge of
the media to the outer end of the slit (excluding corner radii)
may be:
Maximum:
f Detection Slit Height:
Maximum:
Recommended:
Minimum:
Media Type Setup:
• Ticket (w gaps)
Do not allow any perforation to break the edge of the media as this
may cause the media to split and jam the printer.
120.0 mm
25.4 mm
8.0 mm
depends on DRAM size
21.3 mm
1.6 mm
1.2 mm
Intermec EasyCoder 501 XP – User's Guide
(4.72 inches)
(1.00 inches)
(0.32 inches)
5 mm (0.20
50 mm (1.97 inches)
(0.83 inches)
(0.06 inches)
(0.05 inches)