Intermec EasyCoder 501 XP User Manual page 87
Bar code label printer
Hide thumbs
Also See for EasyCoder 501 XP:
- Service manual (210 pages) ,
- User manual (192 pages) ,
- Programmer's reference manual (140 pages)
Table of Contents
Advertisement
Printhead Replacement, cont.
3
Remove the media and transfer ribbon.
5
Disconnect the hooked printhead bracket fi ngers
from the shaft and pull out the printhead as far
as the cables allow.
Intermec EasyCoder 501 XP – User's Guide
Chapter 11
4
Pull the printhead bracket away from the magnet
in the pressure arm.
6
Disconnect the two cables from the printhead. Note
the snap-lock on the outer connector. Pull at the
connectors–not at the cables!
Maintenance
85
- Quick Links:
- Entering the Setup Mode at Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCoder 501 XP and is the answer not in the manual?