Intermec EasyCoder 501 XP User Manual page 99

Media, cont.
Self-Adhesive Labels
a
c
d
SELF-ADHESIVE
LABELS
b
FEED
DIRECTION
Intermec EasyCoder 501 XP – User's Guide
a Media Width (including liner):
Maximum:
Minimum:
b Liner
The liner must not extend more than a total of 1.6 mm (0.06
inches) outside the media and should protrude equally on both
side. Recommended min. transparency: 40% (DIN 53147.)
c Label Width (excluding liner):
Maximum:
Minimum:
d Label Length:
Minimum:
Max label length:
Under ideal circumstances, a minimum label length of 4 mm (0.16
inches) could be used. It requires the sum of the label length (d) and
e
the label gap (e) to be larger than 7 mm (0.28 inches), that batch
printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short labels will work, but it is
up to the user to test this in his unique application.
e Label Gap:
Maximum:
Recommended:
Minimum:
b
The Label Stop Sensor must be able to detect the extreme front
edges of the labels. It can be moved within a range of 0 to 50 mm
(0 to 1.97 inches) from the inner edge of the media.
Media Type Setup:
• Label (w gaps)
Appendix 2 Media Specifi cations
120.0 mm
25.4 mm
118.4 mm
23.8 mm
8.0 mm
depends on DRAM size
21.3 mm
1.6 mm
1.2 mm
(4.72 inches)
(1.00 inches)
(4.66 inches)
(0.94 inches)
(0.32 inches)
(0.83 inches)
(0.06 inches)
(0.05 inches)
97