Intermec Ready-To-Work Indicator - Intermec EasyCoder PF4i User Manual

Chapter 8 — Troubleshooting

Intermec Ready-to-Work Indicator

Displayed Error Messages and LED Indicators
74
The readiness of the printer, individually or as a part of a
solution, is indicated by the blue Intermec Ready-to-Work
Indicator (RTW).
If the RTW blinks or is switched off, the printer is not ready.
Further information can be obtained in the display window by
pressing the i key. In case of several errors or similar conditions
occurring simultaneously, only the most significant error is
displayed. Once this error has been cleared, next remaining error
is displayed.
Provided the printer is connected to a network, all conditions
that prevents printing are reported to the Easy ADC Console.
The Easy ADC Console is a PC-based software which allows a
supervisor to monitor all connected devices that have an
Intermec Ready-to-Work Indicator, including handheld
computers, access points, and printers.
Error/Event
Operational
Out of paper
Out of transfer ribbon
Transfer ribbon is
installed
Head lifted
Cutter error 1
Cutter error 2
Cutter error 3
Lss too high
Lss too low
Testfeed not done
Press feed not done
RTW Displayed Error
Status Message
On
Blink PAPER OUT
Blink RIBBON OUT
Blink RIBBON
FITTED
Blink PRINTHEAD UP
Blink OPEN&SHUT
CUTTER
Blink OPEN&SHUT
CUTTER
Blink OPEN&SHUT
CUTTER
Blink PAPER FAULT
Blink PAPER FAULT
Blink PAPER FAULT
Blink PRESS FEED
EasyCoder PF4i User's Guide (IPL Version)
Comment
Not an error.