Cut-Off - Intermec EasyCoder 501 XP User Manual

Cut-Off

1
Switch off the power using the On/Off switch on
the printer's rear plate.
Intermec EasyCoder 501 XP – User's Guide
The EasyCoder 501 XP can print on labels, tickets, tags, and
continuous stock in various forms. This chapter describes the case
when the media is automatically cut off after printing using an
optional paper cutter.
Use the <Feed> key (see fi gure #14) when loading the same type
of media as before. When switching to a new type of media, or if
the printer does not feed out the media properly, simultaneously
press the <Shift> and <Feed> keys to perform a "testfeed."
Cut-off can be used for:
• Non-adhesive continuous stock
• Self-adhesive labels with liner
Note that the cutter must not cut through the labels–only the
liner–or the adhesive will stick to the blades and render the cutter
inoperable or even damage the cutter's motor!
• Tickets with gaps without perforations
• Tickets with marks without perforations
The rotating cutting blade can be accidently activated when the
cutter is opened. To avoid any risk of injury to fi ngers, always
switch off the power before loading media and/or ribbon in a
cutter-equipped printer.
2
Open the cutter unit and the right-hand door.
Chapter 4
WARNING!
Media Load
23