Media Load - Cut-Off (Option) - Intermec EasyCoder E4 User Manual

Media Load – Cut-Off (option)
1
Load media according to the instructions for tear-off operation, but route the media through the
Intermec EasyCoder E4 – User's Guide
The standard model of EasyCoder E4 can as an option be fi tted
with a paper cutter that can cut of paper strip or liner between
labels. The thickness of the media to be cut should be within
78-175µm (equal to a paper weight between 78 and 175 g/m
Minimum practical copy length is 38.1 mm (1.5 inches).
The cutter cannot be used to cut through any adhesive such as
labels on liner. It cannot be used with LinerLess media.
The cutter is controlled by CUT or CUT ON instructions in the
EasyCoder E4 Direct Protocol.
The cutter can be tilted forward to facilitate cleaning and media
load. A microswitch prfevents the cutter from running when in
open position.
The built-in label taken sensor of the standard EasyCoder E4
does not work when a cutter is installed.
Media load follows the same principles as Tear-Off (Straight-
through) operation, see earlier in this chapter, but route the
media through the cutter as illustrated below.
cutter like this.
Chapter 3 Operation
2
).
19