Cut-Off - Intermec EasyCoder PX6i User Manual

Cut-Off
The EasyCoder PX6i can print on labels, tickets, tags, and continuous
stock in various forms. This section describes the case when the media is
to be cut off by an automatic paper cutter (option).
Cut-off can be used for:
• Non-adhesive continuous stock
• Self-adhesive labels with liner (cut only liner between labels)
The cutter is designed to cut through paper-based media with a thickness
between 60 and 175 µm, which roughly corresponds to a paper weight
of 60 to 175 grams/m
not be used to cut through labels, because the adhesive will stick to the
shears, which can damage the cutter.
The optional label taken sensor cannot be used with the cutter.
The rotating cutting blade can be accidently activated while
the cutter is open. To avoid any risk of injury to fi ngers,
always switch off the power before loading media and/or
ribbon in a cutter-equipped printer.
Note: Save the label indicating the sensitivity number attached
to the media roll. You will need this number to set the media
sensitivity, see Appendix D.
EasyCoder PX6i User's Guide (IPL version)
2
(basis weight 40 to 120 lb.). The cutter should
Chapter 4 — Media Load
23