Advanced Energy
Step 1: External Inspection
1. Inspect the shipping materials and the inverter for any cosmetic or structural
damage. Specifically look for any structural damage or crushing of the base or
doors.
2. Confirm all doors open freely and easily.
The front doors on the main compartments of the inverter have a rotating hand
latch with integral key lock to secure the main compartment doors. All other
access doors on the inverter require that a flat blade screwdriver latch be
released in order to open the doors.
☞
Important
Step 2: Inspection of Rear Magnetics
1. Using a hex wrench remove the large cover plates on the back of the inverter to
access the magnetics.
2. Inspect all nine connections including the following:
a. Three into the inductors
b. Three from the inductors to the transformer
For each connection check the integrity of the bus bar connections and
terminals.
Figure 4‑5. Inductor and transformer connections
4‑6
If the DC circuit breaker option is included, the DC sub panel
compartment will not have a locking door.
Installing
Inspection locations
570-1001791-05A