Figure 4-2. Placing The Air Intake Hood On The Inverter; Figure 4-3. Hinge On The Air Intake Hood - Locked And Open Positions - Advanced Energy AE 600 User Manual

Advanced Energy
Figure 4‑2. Placing the air intake hood on the inverter
5. Set the two back hinges on the rear edge of the air intake hood, on the rear top
edge of the inverter cabinet while aligning the hinge barrels.
6. Rotate the tab on each hinge to unlock the pin. Slide the pin into the cabinet
side of the hinge barrel and lock into place by rotating the tab. This secures the
back hinges.
Figure 4‑3. Hinge on the air intake hood - locked and open positions
7. Remove the tape from the unattached end of the gas springs.
The other end of the gas springs are factory installed to the air intake hood.
8. Lower the loose end of the gas springs to the cabinet and snap into place on the
ball on the inside of the inverter cabinet.
Once the gas springs are attached to the cabinet, they will hold the hood open.
4‑4
Rear hinges
Hinge in locked, open position
Hinge in locked, closed position
Installing 570-1001791-05A