Installing The Air Intake Hoods - Advanced Energy AE 600 User Manual

Advanced Energy
• Lifting device such as a forklift or pallet jack
• Utility knife
The inverter can be moved using a forklift or pallet jack that is rated to handle a
minimum of 4,140 kgs (9,100 lbs).
TO UNLOAD AND UNPACK THE INVERTER
1. Lift and move the inverter using the shipping pallet.
Do not penetrate the packaging or use the inverter base for unloading.
2. Remove the protective plastic wrap encasing the inverter.
If no damage is apparent, proceed with the next step. If you do see signs of
shipping damage, contact AE Solar Energy Technical Support and the carrier
immediately.
3. Using a 3/4" wrench, loosen the bolts and nuts securing the inverter to the
pallet.

Installing the Air Intake Hoods

The air intake hoods may ship in separate packaging from the inverter. If the air
intake hoods are separate, both air intake hoods must be installed as soon as the
protective blue shipping wrap is removed from the inverter. The air intake hoods
prevent water and foreign objects from entering the inverter cabinet.
TOOLS REQUIRED
• Lifting device such as a forklift or overhead crane
• Lifting strap or chain
• Spreader bar
• Eyebolts
• Utility knife
• Flat head screwdriver
TO INSTALL THE AIR INTAKE HOODS
The air intake hoods are installed one at a time. After completing these steps for the
first hood, repeat the steps for the second hood.
1. Unstack the air intake hoods and set them side by side.
4‑2 Installing 570-1001791-05A