XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? false"
Power on the physical partition requiring maintenance.
The ok prompt appears.
Enable the RAID volume to check the status.
M10/SPARC M10 Systems System Operation and Administration Guide
Execute the setpparparam command to activate the Autoboot function of the
control domain.
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? true"
Close the rack door.
7.8.3
System-stopped maintenance
When the system is configured without a hardware RAID
Connect all the power cords to the PSU backplane unit of the chassis
requiring maintenance.
Note -
Return to the operation of the XSCF firmware replacefru command to confirm
that the chassis has been incorporated into the system.
Execute the diagxbu command to diagnose the crossbar cables.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ February 2014
162
Fujitsu