Fujitsu SPARC M10-4 Service Manual page 191

XSCF> showlogs error
Execute the testsb command to confirm that the CPU memory unit requiring
maintenance is normally recognized.
XSCF> testsb -v -y -s 00-0
Execute the setpparparam command to deactivate the Autoboot function of
the control domain.
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? false"
Execute the setpparmode command to deactivate the Autoboot function of
the guest domain.
XSCF> setpparmode -p 0 -m guestboot=off
Start the entire system.
The ok prompt appears.
Enable the RAID volume to check the status.
M10/SPARC M10 Systems System Operation and Administration Guide
Execute the setpparmode command to activate the Autoboot function of the
guest domain.
XSCF> setpparmode -p 0 -m guestboot=on
Execute the showstatus command to confirm that the CPU memory unit is
operating normally after maintenance.
Chapter 7 Maintaining the CPU Memory Units
Fujitsu
167