Fujitsu SPARC M10-4 Service Manual page 461

Figure 28-24
Secure the cable with a clamp.
Support the fan shelf from below with one hand and then insert it carefully
into the chassis.
Tighten the three screws securing the fan shelf.
Connect the two cables to the fan shelf.
Install the lower cover and then secure it with the one screw.
Install the upper cover.
Slide the right and left stoppers of the upper cover outwards and then secure
the cover with the two screws.
Install all the fan units.
Install the front cover.
28.5.2 Installing a cable for the connection between the
terminal board and fan backplane
Install the cable on the terminal board.
Chapter 28 Maintaining the Cable Kit of the Crossbar Box 437