Changing The Communication Channel Of The Hifi And The Loudspeakers - Grundig RCD 8300 Operating Manual

TIME/DATE
10:32
 
1 2 3
 
4 5 6
 
7 8 9

0 DATE

OFF
RDS UPD.

END
CHANNELS
32
SETUP SETTINGS
7 Press »END« to confirm the entries.
8
Press »

Note:
If the date is displayed, only the »TIME« button appears, and if the time is

displayed, only the »DATE« button appears.

Changing the communication channel of the HiFi

and the loudspeakers
If interference occurs during sound transmission, which can happen if another
device is using the same frequency, you can change the communication channel.

There are 16 channels available. When you first set up the system Channel 2 is
selected by default.
If you are also operating WT2, make sure that the HiFi system and the wireless
module are always set to the same channel.
1
Switch the HiFi system and the loudspeakers on from standby mode.
2
Call up the »AUDIO« menu by pressing »Audio« on the remote control.
– Display: the »AUDIO« menu.
3 In the »AUDIO« menu, press »SETUP« and enter the PIN.
– Display: the »SETUP« menu.

4
In the »SETUP« menu, press »CHANNELS«.
– Display: the »CHANNELS« menu, with the active channel indicated.
5
Set a new transmission channel by pressing it.
6
Press »
________________________________________________________________________
« to return to the »SETUP« menu.
« (several times) to return to the »AUDIO« menu.