Connecting And Installing The Active Loudspeakers - Grundig RCD 8300 Operating Manual

INSTALLATION

Connecting and installing the active loudspeakers

Mains switch
Operation indicator
___________________________________________________________________________
The HiFi transmits audio signals by radio to the loudspeakers. Speaker cables
are not required.
You can operate up to 2 pairs of loudspeakers in room 1, where the HiFi system
is located. To install pairs of loudspeakers in other rooms, see the "MULTI-
ROOM MODE" section starting on page 35.
The transmission power is < 10 mW. This guarantees an unhindered reception
range of approximately 100 m. This range is restricted inside buildings, depen-
ding on the construction materials used.
The illustrations in the examples show the LSP2 active loudspeakers. The positio-
ning of the loudspeakers and the function of the operation indicators are descri-
bed in the LSP2 and LSP3 operating manuals.
Preparing the HiFi system and the loudspeakers for
installation
Note:
Please be sure to adhere to the sequence outlined here.
There must be no batteries in the battery compartment.
1
Insert the power cord plug (HiFi system and active loudspeakers) into the
socket.
Note:
The HiFi system and the loudspeakers must be switched off at their mains
switches.
11