Installing The Wt2 Module; In Configuration With Digi 100 Televisions, E.g. Lenaro - Grundig RCD 8300 Operating Manual

INSTALLING THE WT2 MODULE

If you want to operate the loudspeakers in room 1 on both the HiFi and the tele-
vision, you have to install the WT2 wireless module provided for the television
on the HiFi system. The WT2 wireless module and the HiFi system must be co-
ordinated, because the HiFi system has priority when you are operating both
systems alternately, and it must therefore be able to communicate with the WT2
wireless module.
... in configuration with Digi 100 televisions,
e.g. Lenaro
A condition for the process described here is that the WT2 wireless module must
be connected to the television via the I
one pair of loudspeakers must be installed on the WT2. For this reason the
description applies to two cases:
1. You are operating the WT2 and are installing the HiFi system at a later date.
2. You are installing the WT2 and the HiFi system at the same time, but you are
installing the loudspeakers on WT2 first.
For the I
vision screen (see the WT2 installation and operating manual).
Note:
For the installation of the loudspeakers on WT2, see the relevant section in
the WT2 operating manual (pages 41 to 43).
1
Insert the power cord plug of the HiFi into the socket.
Note:
The mains switch of the HiFi must be turned off.
There must be no batteries in the battery compartment.
2
Switch on the television and the loudspeakers with their mains switches.
– You will hear the sound from the television.
2
C connection, the WT2 is installed on the HiFi via the menu on the tele-
2
C socket of the television, and at least
_________________
43