General Functions; Switching On; Switching Off - Grundig RCD 8300 Operating Manual

GENERAL FUNCTIONS

Switching on

1
Use the mains switch on the loudspeakers to switch them into standby mode.
– The mode indicators on the loudspeakers light up orange.
2 Switch on the HiFi system by pressing the mains switch on the back of the
HiFi.
– The HiFi system switches on with the input source last selected.
– The loudspeakers in room 1 switch on automatically and the mode indica-
tors on the loudspeakers light up green.
Note:
If the HiFi system had been in standby mode before it was switched off using
the mains switch, it automatically returns to standby when you then press the
mains switch again.
The only way to isolate the HiFi system and the loudspeakers from the mains
supply is to pull the mains plugs.

Switching off

1 First turn off the loudspeakers with the mains switches, then turn off the HiFi
system with the mains switch.
Notes:
After you have installed the system, we recommend that you only use the
»9« button to switch the HiFi and the loudspeakers to standby, and to
switch them on from standby. You should not use the mains switches for swit-
ching on and off any more.
The following applies for multi-room mode: If, for example, the loudspeakers
in room 3 are switched to stand-by mode and are then switched on again,
the FM input source is always played instead of the last input source
selected.
_________________________________________
17