In Configuration With The Finearts Vision And Finearts Planavision Televisions - Grundig RCD 8300 Operating Manual

INSTALLING THE WT2 MODULE
INSTALLATION
LANGUAGE:

ENGLISH

DEUTSCH

FRANCAIS

ITALIANO
 
c x

CANCEL
... in configuration with the FineArts Vision and
FineArts Planavision televisions
A condition for the procedure described is that the WT2 wireless module must
be connected to the television and be configured appropriately. In addition, at
least one pair of speakers must be installed on the WT2 (see the WT2 installati-
on and operating manual). For this reason the description applies to two cases:
1. You are operating the WT2 and are installing the HiFi system at a later date.
2. You are installing the WT2 and the HiFi system at the same time, but you are
installing the loudspeakers on WT2 first.
Note:
For the installation of the loudspeakers on WT2, see the relevant section in
the WT2 operating manual (pages 38 to 40).
1
Insert the power cord plug of the HiFi into the socket.
Note:
The mains switch of the HiFi must be turned off.
There must be no batteries in the battery compartment.
2
Switch on the television and the loudspeakers with their mains switches.
– You will hear the sound from the television.
3 Switch on the HiFi with the mains switch.
– The HiFi display reads: »INSERT BATTERIES INTO THE PR1 AND PRESS
"OK" FOR 2 SECONDS«.
4
Insert the three batteries supplied into the remote control battery compart-
ment, making sure the polarity is correct. Then press »OK« on the remote
control and hold it down for 2 seconds.
– The touchpad display of the remote control switches on.
– The languages installed are displayed, e.g.: »INSTALLATION LANGUA-
GE: ENGLISH DEUTSCH FRANCAIS ITALIANO«.
_____________________________________________
47