Resetting Components To The Original State - Grundig RCD 8300 Operating Manual

INFORMATION
 
SETUP M-ROOM

INSTALLATION

RESET

RESET
__________________________________________________________________________

Resetting components to the original state

Caution:
The system is shut down completely. All the components are then in their ori-
ginal states. The transmission/reception channel is reset to channel 2. After-
wards, the system must be installed again. See the section entitled "Installing
the first pair of loudspeakers (room 1)" starting on page 12.
Resetting the remote control
If the entire system is reset, all the remote controls must be reset individually.
1
Call up the »AUDIO« menu by pressing »Audio« on the remote control.
– Display: the »AUDIO« menu.
2
In the »AUDIO« menu, press »SETUP« and enter the PIN.
– Display: the »SETUP« menu.
3
In the »SETUP« menu, press »INSTALLATION«.
– Display: the »INSTALLATION
4
In the »INSTALLATION« menu, press »RESET«.
– Display: the »RESET« menu with the message »ATTENTION: "RESET"
RESETS THE PR1
5
To reset the remote control, press »RESET«.
« menu.
«.
57