Table of Contents
Advertisement
INSTALLATION
INSTALLATION
INSTALL
WT2 MODULE?
YES
NO
INSTALLATION
PLEASE CONNECT
ANTENNA
THEN PRESS
"CONTINUE"
CONTINUE
___________________________________________________________________________
8
To install the WT2 wireless module, press »YES« on the remote control.
Note:
Note also the description of the reinstallion of the WT2 wireless module on
pages 48 to 54.
or
To end the procedure, press »NO« on the remote control.
– The HiFi has meanwhile started the automatic station search (ASP). If a
DAB module is integrated, the HiFi first searches for DAB stations, then
radio stations in the FM range. After the search is complete, the first
station found is played.
Note:
If no radio stations are found, the following appears briefly in the remote con-
trol display: »PLEASE CONNECT ANTENNA.
NUE".«
You can only continue if you press »CONTINUE«. If no antenna has been
connected, the system will work without it. However, you now have to start
the ASP search manually by pressing »ATS SEARCH« in the »FM PRE-
SETS« menu (see page 21).
If you want to install more pairs of loudspeakers, see the "MULTI-ROOM
MODE" section on pages 35 to 41 for instructions.
Please note that during normal operation the remote control switches off
when no button has been pressed for 30 seconds, to conserve the batteries.
Press »OK« to switch the remote control on again.
If there is interference in the transmission of radio signals, you can adjust the
communication channel (see the relevant section on page 31).
"CONTI-
THEN PRESS
15
Advertisement
Chapters
Table of Contents
