Grundig RCD 8300 Operating Manual page 108

INSTALLATION
LANGUAGE:
ENGLISH
DEUTSCH
FRANCAIS
ITALIANO

c x
CANCEL
INSTALLATION
PLEASE CHOOSE
POSITION:
HORIZONTAL
VERTICAL
CANCEL
44
INSTALLING THE WT2 MODULE
3 Switch on the HiFi system by pressing the mains switch on the back of the
HiFi.
– The HiFi display reads: »INSERT BATTERIES INTO THE PR1 AND PRESS
"OK" FOR 2 SECONDS«.

4 Insert the three batteries supplied into the remote control battery compart-

ment, making sure the polarity is correct. Then press »OK« on the remote
control and hold it down for 2 seconds.

– The touchpad display of the remote control switches on.
– The languages installed are displayed, e.g.: »INSTALLATION LANGUA-

GE: ENGLISH DEUTSCH FRANCAIS ITALIANO«.

5
Select a menu language by pressing one.
– The remote control display reads: »INSTALLATION PLEASE CHOOSE

POSITION: HORIZONTAL VERTICAL«.
6 Press »HORIZONTAL« or »VERTICAL« to select the future operating mode.
– The remote control display reads: »INSTALLATION
LEFT SPEAKER« (Because the loudspeakers are already installed on
WT2, you do not have to switch them on. Continue with step 7).
7 Press the »RESET« button on the left speaker until the indicator flashes oran-
ge. The display switches to flashing green.
– The left loudspeaker has been detected.
– The remote control display reads: »INSTALLATION
RIGHT SPEAKER« (Because the loudspeakers are already installed on

WT2, you do not have to switch them on. Continue with step 7).


_____________________________________________
SWITCH ON THE
SWITCH ON THE