Loading Transparencies In The Ohcf - Xerox 4112 User Manual

Loading transparencies in the OHCF

Use the following procedure to load transparencies into either tray of the OHCF.
1. Select the appropriate transparency stock for your job.
2. Pull out the tray slowly until it stops.
3. Fan the transparencies to stop them from sticking together before loading them into the
tray.
4. Load transparencies on top of a small stack of the same-size paper and align the edge of
the transparencies against the right edge of the tray as shown in the following illustration:
5. Adjust the paper guides by pressing in the guide release and carefully moving the Edge
Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
6. If necessary, set the skew adjustment levers to the desired position for your print job; refer
Skew adjustment levers on page 14-8.
7. Gently push in the tray until it comes to a stop.
Xerox 4112/4127 Copier/Printer
User Guide
Addendum
14-5