Hints And Tips For Using The Hcs; Fault Codes - Xerox 4112 User Manual

Hints and Tips for using the HCS

1. Check the paper in the Stack Tray for curl.
• No, curl is not present.
• If the output acceptable and meets customer satisfaction, you are finished.
• If the output is not acceptable, call for service.
• Yes, curl is present: continue to the next step.
2. Adjust the paper curl by using the Decurler Controls on the top of the Interface Module;
refer to page 18 for more information on adjusting paper curl.
3. If the output has not improved, adjust the paper curl again.
4. If the output still has not improved, call the Customer Support Center.

Fault Codes

Fault code Possible cause
049 100 Paper jam
049 101 A jam occurred during
049 102 feeding
049 104 A jam notification is
049 106 displayed on the UI
049 108
049 113
049 114
049 115
049 116
049 117
049 119
049 121
049 900
049 901
049 902
049 903
049 905
049 907
049 908
049 210 Front door sensor
049 211 problem
049 212 Stacker tray did not raise
049 213 or lower properly
049 214 Sensor problem/failure
049 215
049 216
049 217
049 218
049 219 Front door software
failure
049 220 Stacker upper limit failure
049 221 Stacker lower limit failure
Recommended solution
Open the front door.
Carefully remove all sheets and paper scraps from jam
clearance areas.
Close the front door.
Verify the paper used is within the approved paper
specifications.
Power off, then power on
Power off, then power on
Power off, then power on
The front door switch is detected as "open," but the front
door is actually closed (locked). Power off, then power on.
Power off, then power on
Xerox 4112/4127 Copier/Printer
Addendum
14-27
User Guide