Xerox 4112 User Manual page 333

Category
Error Code
C P S
m
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-790
116-780
123-400 m
127-210 m
127-211 m
127-212 m
127-213 m
127-220 m
127-221 m
m
127-311
O
M
Cause: There was a problem with parameters in the JBIG data. They
were automatically edited.
Remedy: If any problem occurs in job result, try to process the job
again.
m m Cause: There is a problem with the document attached to the
received mail.
Remedy: Check the attached document.
Cause: A malfunction occurred in the machine.
Remedy: Power-cycle the machine. If the machine error is not fixed
by performing the relevant remedy, contact the Customer Support
Center.
m Cause: Communication error between the printer and the
controller. Error detected by the printer.
Remedy: Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the printer and
the controller. If the problem persists, call the Customer Support
Center.
m Cause: Detected a communication error between the printer and
the controller.
Remedy: Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the printer and
the controller. If the problem persists, call the Customer Support
Center.
m Cause: Detected an internal print check error by the controller.
Remedy: Remove and reinsert the command/video cable between
the controller and the printer. Power off and on both the printer
and the controller. If the problem persists, call the Customer
Support Center.
m Cause: Detected a mismatch with the software version of the
controller.
Remedy: Contact the Customer Support Center for information
and/or instructions to remedy the problem.
m Cause: Detected a communication error of the video system by the
controller.
Remedy: Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the printer and
the controller. If the problem persists, call the Customer Support
Center
m Cause: Detected a communication error by the controller.
Remedy: Remove and reinsert the cable connection between the
printer and the controller. Power off and on both the printer and
the controller. If the problem persists, call the Customer Support
Center.
m Cause: Detected a fatal error by the controller.
Remedy: Power on/off both the controller and the printer. If the
problem persists, contact the Customer Support Center.
Cause and Remedy
Xerox 4112/4127 Copier/Printer
User Guide
Problem Solving
12-39