Loss Of Power; Specifications; Paper Guidelines - Xerox 4112 User Manual

Fault code Possible cause
049 945 The UI displays a
message indicating that
the Top Tray is full.
049 960 Message on machine UI
states that the Stacker
Tray needs to be empty
before reaching its full
capacity.
049 960 The UI displays the
049 961 following message, "Take
049 962 out the paper stack."
049 963
049 964
049 967
049 969
049 970
049 971
049 972

Loss of power

If power is interrupted to the HCS:
• Ensure the power cord is plugged in to the proper wall receptacle
• Ensure that the machine power is switched "On"
• Ensure that the Ground Fault Indicator is in the "On" position
• If the power has not been restored by checking the above items, then call for service

Specifications

Paper guidelines

• Stacker Tray will accept 64-280 gsm (either coated or uncoated stock) with the possibility
of degraded stock quality and increased jam rate
• Transparencies may be run to either the Top Tray or the Stack Tray. Stack height should be
limited to 100 transparencies.
• Coated paper lighter than 100 gsm may not run as reliably as coated paper heavier than
100 gsm.
• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210 mm
(8.3 in.) minimum measurement across the feed direction.
• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require 330
mm (13 in.) minimum measurement in the feed direction.
Recommended solution
Remove all the paper from the Top Tray.
• Empty the Stacker Tray.
• Check the output at the for paper curl exceeding 1 in./
25.4 mm.
• If the paper curl on the output exceeds 1 in./25.4 mm,
adjust the paper curl at the Interface Module; refer to
page 18 for specific instructions.
Press the Unload button. The Wait light blinks until the
Stacker Tray has reached the down position.
When the Stacker Tray has reached the down position,
open the front door.
Remove the Stacker Cart.
Remove all the stacked paper.
Position the Stacker Cart securely into the HCS.
Close the front door.
Power off, then power on
Xerox 4112/4127 Copier/Printer
Addendum
14-29
User Guide