Displaying and maintaining IPv6 Telnet
To do...
Display the use information of
the users who have logged in
IPv6 Application Configuration Example
IPv6 Applications
Network requirements
In
Figure
2-3, SWA, SWB, and SWC are three switches, among which SWA is an H3C S5100-SI/EI
Ethernet switch, SWB and SWC are two switches supporting IPv6 forwarding. In a LAN, there is a
Telnet server and a TFTP server for providing Telnet service and TFTP service to the switch respectively.
It is required that you telnet to the telnet server from SWA and download files from the TFTP server.
Network diagram
Figure 2-3 Network diagram for IPv6 applications
Configuration procedure
You need configure IPv6 address at the switch's and server's interfaces and ensure that the route
between the switch and the server is accessible before the following configuration.
# Ping SWB's IPv6 address from SWA.
<SWA> ping ipv6 3003::1
PING 3003::1 : 64
Reply from 3003::1
Use the command...
display users [ all ]
data bytes, press CTRL_C to break
2-4
Remarks
Available in any view