Setting The Energy Save Timers Of The Digital Copier - Oce VarioPrint 2062 NC User Manual

Setting the energy save timers of the Digital Copier

Introduction
You can set the following energy save timers
the Digital Copier' on page
The low power timer (range 1 to 15 minutes).
The automatic switch off (range 1 to 90 minutes).
You can change the default values of the low power timer (15 minutes) and the
automatic switch off (90 minutes).
If the default values result in problems, due to the usage pattern, you can request the
Océ Service to increase the limits of both timers to a maximum of 240 minutes.
The machine requires 8 seconds to switch back from the low power mode.
The machine requires 8 minutes to switch back from the automatic switch off.
Before you begin
Enter the Key operator system
page 28).
Illustration
[75]
[75] Setting the energy same timers on the Digital Copier
How to set the low power timer
Press the 'Machine' key.
1.
Select the 'Basic settings' tab.
2.
Press the 'Energy save timers' key to select 'Low power after'.
3.
Use the scroll wheel to select a value.
Setting the energy save timers of the Digital Copier
(see 'About the energy save modes of
106).
(see 'Enter or quit the key operator system' on
107