Oce VarioPrint 2062 NC User Manual page 139

[104]
[104] Remove the empty staple cartridge from the internal stapler
[105]
[105] Remove the empty staple cartridge from the off-line stapler
Accessing the staple cartridge
Loosen the screw of the latch on the stapler unit.
1.
Move the latch backwards.
2.
Pull the lever backwards and lift out the stapler unit.
3.
The stapler unit turns over.
Remove the empty staple cartridge.
4.
Adding the new staple cartridge
Remove any individual staples that have remained in the staple path and on the anvil.
1.
Slide a new staple cartridge in the stapler unit until the cartridge clicks into place.
2.
How to close the internal stapler unit
Turn over the stapler unit.
1.
Pull the lever of the stapler unit backwards and push the stapler down as far as it goes.
2.
Release the lever.
Move the latch forwards and tighten the screw.
3.
Closing the covers and doors
Lower the top cover.
1.
Slide the frame to the left until the frame locks in position.
2.
Close the paper-compartment door.
3.
Adding Staples
139