Setting the energy save timers of the Network Printer
Introduction
You can set the following energy save timers
the Network Printer' on page
The low power timer (range 1 to 15 minutes).
The sleep mode timer (range 1 to 90 minutes).
You can change the default values of the low power timer (15 minutes) and the sleep
mode timer (90 minutes).
If the default values result in problems, due to the usage pattern, you can request the
Océ Service to increase the limits of both timers to a maximum of 240 minutes.
The machine requires 8 seconds to switch back from the low power mode.
The machine requires 7 minutes to switch back from the sleep mode.
Before you begin
Enter the Key operator system
page
28).
Illustration
[73]
[73] Set the energy save timers
Setting the low power timer
Press the 'Machine' key.
1.
Select the 'Basic settings' tab.
2.
Press the 'Energy save timers' key to select 'Low power after'.
3.
Use the scroll wheel to select a value.
Setting the energy save timers of the Network Printer
(see 'About the energy save modes of
102).
(see 'Enter or quit the key operator system' on
103