Enable The Copy Control Device Connected To The Digital Copier - Oce VarioPrint 2062 NC User Manual

Enable the Copy control device connected to the Digital Copier

Enable the Copy control device connected to the Digital
Copier
Introduction
The Copy control device is connected externally to the machine
access-secured system of the Digital Copier' on page
to external users who are not authorized in the accounts database. The external user
must insert coins or a credit card to gain access to the machine.
Océ Service must install and configure the copy control device.
You can enable or disable an installed and configured copy control device.
An enabled Copy control device and an access-secured system can be combined, to
enable use by internal and external user groups.
[49]
[49] Entry screen for external users
The following table displays the requirements for the external users when the copy
control device is enabled:
[20]
Job
Copy job
Before you begin
Enter the Key operator system
page 28).
62 Chapter 7 The Access Security
Requirement
The user must insert coins or a
credit card, to access the machine.
(see 'Enter or quit the key operator system' on
(see 'About the
56). The system gives access
Charges
Jobs are charged to the 'Copy
control device' system
account.