Disabling The Side Correction - Oce VarioPrint 2062 NC User Manual

Disabling the Side Correction

Disabling the Side Correction
Introduction
The side correction feature of the Océ VarioPrint
Module controls the exact positioning of the material from the paper trays to the
printing unit.
You must disable the side correction in the following circumstances.
The paper trays are filled with unbacked overhead sheets.
The use of unbacked overhead sheets in the paper trays can result in a
side-correction error. The use of overhead sheets in the special feeder cannot
result in side-correction errors.
The Océ VarioPrint
You are requested to switch the machine off and then back on. If the problem
re-occurs, you must disable the side correction. Inform Océ Service about the
side-correction failure during the next visit of the Service technician. You can
still use the machine for the jobs, when you have disabled the side correction.
Before you begin
Enter the Key operator system
page 28).
Illustration
[90]
[90] Disabling the Side Correction
How to disable the side correction
Press the 'Machine' key.
1.
Select the 'Special' tab.
2.
Press the 'Finishing jobs' key to select the 'Side correction' values.
3.
Use the scroll wheel to select 'Disabled'.
4.
128 Chapter 15 Finishing Jobs
®
2062/75 NC reports when the side correction has failed.
(see 'Enter or quit the key operator system' on
®
2062/75 NC Paper Positioning