TRENDnet User's Guide
TEW-841APBO Basic Installation and
Configuration (Basic Access Point Setup)
The following installation procedure is for setting up the TEW-841APBO as a basic
outdoor Omni-directional access point.
Hardware Setup
1. Attach the antennas as shown in the following image.
NOTE: There are two different sets of antennas, one tuned for 2.4GHz, the other
tuned for 5GHz. Be sure to attach each antenna to its respective band for optimal
performance.
© Copyright 2019 TRENDnet. All Rights Reserved.
Basic Access Point Configuration
Note: It is strongly recommended to configure the access point first, prior to mounting.
1. Using a RJ-45 network cable, connect the cable from the LAN (PoE) port of your
access point, to an available LAN PoE+ port on your networked switch or PoE+
injector.
2. Using another RJ-45, connect your computer's Ethernet port to the same PoE+
device chosen in step 1.
TEW-841APBO
8