Table of Contents
Advertisement
TRENDnet User's Guide
PPTP:
•
The Point-to-Point Tunneling Protocol (PPTP) mode enables the
secure multi-protocol Virtual Private Networks (VPNs)
• IP Address: The IP address of the WAN port
• IP Netmask: The Subnet mask of the WAN port
• PPTP Server IP Address: The IP address of the PPTP server
• User Name : Enter User Name for PPTP connection
• Password: Enter Password for PPTP connection
• Reconnect Mode:
Always on: A connection to Internet is always maintained.
o
On Demand: A connection to Internet is made as needed.
o
Manual: Click the "Connect" button on "WAN Information" in the Overview page
o
to connect to the Internet.
• Idle Time: Time to last before disconnecting PPPoE session when it is idle. Enter
preferred Idle Time in minutes. Default is "0", indicates disabled. When Idle time is
disabled, the "Reconnect Mode" will turn out "Always on"
• MTU: By default, it's 1460 bytes. MTU stands for Maximum Transmission Unit.
Consult with WISP for a correct MTU setting.
• MPPE Encryption: Microsoft Point-to-Point Encryption (MPPE) encrypts data in
Point-to-Point Protocol (PPP)-based dial-up connections or Point-to-Point Tunneling
Protocol (PPTP) virtual private network (VPN) connections. 128-bit key (strong) and
40-bit key (standard) MPPE encryption schemes are supported. MPPE provides data
© Copyright 2014TRENDnet. All Rights Reserved.
implementation of
through public networks.
security for the PPTP connection that is between the VPN client and the VPN server.
• DNS: Check "No Default DNS Server" or "Specify DNS Server IP" radial button as
desired to set up system DNS.
• Primary: The IP address of the primary DNS server.
• Secondary: The IP address of the secondary DNS server.
Click Save button to save your changes. Click Reboot button to activate your changes
Configure DDNS Setup
Dynamic DNS allows you to map domain name to dynamic IP address.
Please click on System -> DDNS Setup and follow the below setting.
• Enabled: By default, it's "Disable". The mapping domain name won't change when
dynamic IP changes. The beauty of it is no need to remember the dynamic WAP IP
while accessing to it.
• Service Provider: Select the preferred Service Provider from the drop-down list
including dyndns, dhs, ods and tzo
• Hostname: Host Name that you register to Dynamic-DNS service and export.
• User Name & Password: User Name and Password are used to login DDNS service.
Click Save button to save your changes. Click Reboot button to activate your changes
TEW-738APBO
52
Advertisement
Table of Contents
