Enable Upnp; Backup / Restore And Reset To Factory - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide
o ro community: Set a community string to authorize read-only access.
o rw community: Set a community string to authorize read/write access.

SNMP v3 Enable: Check to enable SNMP v3. SNMPv3 supports the highest level
SNMP security.
o SNMP ro user: Set a community string to authorize read-only access.
o SNMP ro password: Set a password to authorize read-only access.
o SNMP rw user: Set a community string to authorize read/write access.
o SNMP rw password: Set a password to authorize read/write access.

SNMP Trap: Events such as cold start, interface up & down, and association &
disassociation will report to an assigned server.
o Community: Set a community string required by the remote host computer that
© Copyright 2016 TRENDnet. All Rights Reserved.
will receive trap messages or notices send by the system.
o IP: Enter the IP addresses of the remote hosts to receive trap messages.
Click Save button to save changes and click Reboot button to activate.

Enable UPNP

Enable UPNP protocol on the access point.
 Service:
o Enable: Select to enable UPNP through the access point
o Disable: Select to disable UPNP

Backup / Restore and Reset to Factory

Backup current configuration, restore prior configuration or reset back to factory default
configuration can be executed via this page.
Please click on Utilities -> Profile Setting and follow the below setting.

Save Settings to PC: Click Save to save current access point configuration settings
to a computer.

Load Settings from PC: Click Browse button to locate a configuration file to restore,
and then click Upload button to upload.

Reset To Factory Default: Click Default button to reset back to the factory default
settings and expect Successful loading message. Then, click Reboot button to
activate.
TEW-740APBO
83