Configure Led Indicators; Backup / Restore System Settings - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide
5
If you have a preferred NTP server, check the Enable NTP Server and enter the NTP
server IP address. Otherwise, leave it unchecked to use the TEW-821DAP's default NTP
server.
6
Click Apply to save the changes or Cancel to discard the changes.

Configure LED Indicators

Management > LED Control
All LED indicators are turned on by default. You can turn any one of them or all of them
on or off.
1
Log into your access point management page (refer to
on page 10).
2
Click Management > LED Control.
3
Click the following LED to turn it on or off:
• Power LED:
ƒ OFF: Powered off.
ƒ Solid Orange: System is under Power-ON booting process.
ƒ Solid Green: System is ON. (Booting process is done.)
• Network LED (Orange: 10/100; Green: Giga bit):
ƒ OFF: No link.
ƒ Solid green: The device's Ethernet port is connected to an active router or
switch.
ƒ Blinking green: Data transmission.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Log in to Management Page"
• Wireless LED (Orange: 2.4GHz; Green: 5GHz):
ƒ OFF: No link.
ƒ Blinking green: Data transmission.

Backup / Restore System Settings

Management > Backup/Restore Settings
This page allows you to save the current configurations, load previously saved
configurations, and reset TEW-821DAP's configurations back to factory defaults.
1
Log into your access point management page (refer to
on page 10).
2 Click Management > Backup/Restore Settings.
3
Do any of the following:
• Click Export to save the current configuration of the AP.
• To load a configuration file, do the following:
a) Click Browse to load the configuration file.
b) Enter the encryption key.
c) Click Import.
The new configuration file will be saved and encrypted with this new key.
• Click Load Default if you want to reset TEW-821DAP's configurations back to
factory defaults.
TEW-821DAP
"Log in to Management Page"
46