HP-UX and MPE/iX
Verifying the Host Configuration
For Sun Solaris™ operating systems, perform the following operating system
Install the appropriate host bus adapter(s)
Install the corresponding drivers for the interface card(s)
To verify the hardware installation, look for the library and drives after
powering up the host.
— Close all open applications and exit the Common Desktop
— Type "init 0" at any prompt. This will shut down all processes, and
take you to the OpenBoot PROM.
— Type "reset".
— At the OK prompt, type "probe-scsi-all".
Install the backup software
Run a test backup to ensure that all components are properly configured.
For more information on configuring these operating systems and verifying the
connection, see the online configuration and diagnostic guide at http://
www.hp.com/go/support. Select your product and then select [manuals].