Enabling And Changing The Password - HP Surestore Tape Library Model 2/20 User Manual

Enabling and Changing the Password

92 Configuring the Library
Note Administration procedures can be password protected. These
procedures include: diagnostic tests, configurations, online drive
repair, and setting the date and time. A password is also
required for administration through the remote management
card.
Main Menu -> Administration -> Change Configuration -> Password
When the library is first installed, the password is inactive. To protect the
system from unauthorized access, use the following procedure to set a
password.
1. Enter the
Password
enabled.
— If the password is turned off, select
password.
— If the password is turned on, select
password. It must be exactly eight digits.
— If the password is turned on, select
password.
If you enter more than eight digits, the ninth digit will become
Note
the first digit of the new password.
2. Select to exit.
[OK]
Caution Be sure to document the password. If you forget the password,
contact your service representative.
menu. A status screen will indicate if a password is
Set New Password
Change Password
Turn Password Off
to enable the
to enter the new
to clear the
Chapter 3